Advanced Instruments 4C3, User Manual

Page: 31 / 139

9. Close the printer door and take up any slack by pulling the end
of the paper.
F. Power-up
When the instrument has been unpacked and installed as recom-
mended in sections A, D and E, you may start it as follows:
1. Make sure the power cord is connected to the 4C3 and the
power outlet.
2. Place the POWER switch on the back of the instrument (see
figure 7) in the on ( l ) position. Each time it is turned on, the
4C3 prints the manufacturer’s name, address, telephone, FAX,
and Internet address, and then displays and prints the instrument
model, software version, copyright notice, serial number, date
and time, and the probe bin numbers. Your readout should look
similar to the following:
Advanced Instruments, Inc.
Two Technology Way
Norwood MA 02062, USA
Phone: +US 781-320-9000
Service fax: +US 781-320-0811
Supplies fax: +US 781-320-3669
INTERNET http://www.aicompanies.com
Model 4C3
Version 4.0
(C) 2002 A. I., Inc.
Serial#:123456789012
01/30/98 11:09 am
[ON]< Batch *[OFF]
[ON]< Barcode *[OFF]
30 Second Timed
Amplitude = 35
Block: 5 Sample: 3
Save the printed information with the service log at the end of this
user’s guide to facilitate any necessary service.
9
Installation & Setup