ABB Relion REC670, Applications Manual

Page: 462 / 658

NrPos : Sets the number of positions in the switch (max. 32).
OutType : Steady or Pulsed .
tPulse : In case of a pulsed output, it gives the length of the pulse (in seconds).
tDelay : The delay between the UP or DOWN activation signal positive front and the
output activation.
StopAtExtremes : Sets the behavior of the switch at the end positions – if set to
Disabled , when pressing UP while on first position, the switch will jump to the last
position; when pressing DOWN at the last position, the switch will jump to the first
position; when set to
Enabled , no jump will be allowed.
14.7 Selector mini switch VSGAPC
SEMOD158754-1 v3
14.7.1 Identification
SEMOD167850-2 v4
Function description IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Selector mini switch VSGAPC - 43
14.7.2 Application
SEMOD158803-5 v8
Selector mini switch (VSGAPC) function is a multipurpose function used in the
configuration tool in PCM600 for a variety of applications, as a general purpose
switch. VSGAPC can be used for both acquiring an external switch position (through
the IPOS1 and the IPOS2 inputs) and represent it through the single line diagram
symbols (or use it in the configuration through the outputs POS1 and POS2) as well as,
a command function (controlled by the PSTO input), giving switching commands
through the CMDPOS12 and CMDPOS21 outputs.
The output POSITION is an integer output, showing the actual position as an integer
number 0 – 3, where 0 = MidPos, 1 = Open, 2 = Closed and 3 = Error.
An example where VSGAPC is configured to switch Autorecloser enabled–disabled
from a button symbol on the local HMI is shown in figure
185 . The Close and Open
buttons on the local HMI are normally used for enable–disable operations of the circuit
breaker.
Section 14
1MRK 511 401-UUS A
Control
456 Bay control REC670 2.2 ANSI
Application manual