Waygate Technologies Krautkramer USM 100, Руководство по эксплуатации, Страница: 143 / 330

UT Setup 5 Operation
Krautkrämer USM 100 Rev. 9 (09/2023) 143
Alarm Select
You can assign an alarm event to the alarm output. If the
alarm event occurs, a signal is output via the TTL alarm
output (see page 271). Here you can select the gate for
triggering the alarm.
Averaging
This is the same function as in the function group
Pulser Receiver (see page 135).
Magnify gate
You can choose a gate for the Magnify Gate function in
the Command bar (see page 76). The selected gate will
be spanned over the entire displayed range.
Analog Output
You can output measurement results via analog output
(see page 271) for external further processing.
Use this function to specify the reading to be output as
voltage signal.
If Amp (amplitude) is selected, the following applies to
the output voltage:
0 V = 0 % screen height,
5 V = maximum screen height.
If saturation is set in the application (only possible with
the software Mentor Create ), then the maximum screen
height is 400 %, for example. This means that the output
voltage also applies to the range from 0 % to 400 %
screen height. In this case 100 % screen height would
generate 1.25 V output voltage.
If TOF (time of flight) is selected, the following applies to
the output voltage: .
0 V = measuring point at the start of the gate,
5 V = measuring point at the end of the gate.