Vision MaxPro, Руководство по эксплуатации

Страница: 50 / 203

Vision MaxPro 46
© 2006 Vision Engraving Systems
Click the Apply button.
Click on the Engraver: tab from the Engraver Setup screen and highlight the MaxPro
Outside Ring driver. Change the Port Location to the COM port required in the same
manner that was done for the MaxPro Inside Ring driver. Do this for the remaining four
drivers and then click OK two times.
The Vision Pro software configuration is now complete.
Table setup
T-Slot table
The T-Slot table is typically used for engraving larger, flat items such as plaques and name
tags. The quick lock vice included with the machine can be used to hold smaller items. If
items are larger in size, either double sided tape or "Multi Mat" material can be used to hold
the part down to the table. More information on the "Multi Mat" material can be found in the
Vision accessory catalog or online at
www.visionengravers.com under the accessories web
page.
The T-Slot table is typically mounted on the machine during the initial machine shipment.
When putting material on the T-Slot table, always place the material to be engraved against
the back, left side of the T-Slot table. These are the sides that have the ruler guides on
them per the picture below.