Viessmann VITOCAL 200-G, Инструкция по установке и обслуживанию

Страница: 19 / 208

qR
Natural cooling extension kit
qT
Central fault message (230 V)
qZ
Power-OFF
qI
KM BUS: Vitotrol 200 remote con-
trol (with room temperature sen-
sor), see also page 77
qO
Room temperature sensor (if no
remote control is installed), see
also page 77
wP
KM BUS: Extension kit for cooling
circuit with mixer
wQ
Outside temperature sensor
Connections to control module X80, 400 V
A
Front of control module (with type
plate)
B
Compressor power supply
C
Internal connection to control
panel
D
Primary pump connection (230 V)
E
Compressor safety chain connec-
tion
F
Phase monitor plug-in location
(accessories)
G
Strapping plug or phase monitor
connection
H
Compressor contactor
K
Compressor or full wave soft star-
ter connection
L
Primary temperature sensor (for
control purposes)
M
Heat pump module
N
Direct connection only with
BWP 106
O
Connection required as of
BWP 108
P
Connection required as of
BWP 108
R
Full wave soft starter (as of
BWP 108)
Information regarding other connections
The primary pump, the secondary pump, and the heating/DHW three-way valve
have already been connected in the factory.
System version 1
(cont.)
19
Preparing for installation
55
92
968
GB
Installation