Viessmann VITOCAL 200-G, Инструкция по установке и обслуживанию

Страница: 145 / 208

This setting determines whether the heat pump is used to dry the building as
well as the instantaneous heating water heater.
This function must be set to "
NO " if the heat pump is not ready for operation
because the heat pump primary circuit is not ready when building drying takes
place.
Access
& " Device settings "
& " Programming "
& " Internal hydraulics "
& "HP for drying buildings"
("YES"/"NO")
Standard setting NO
Setting range YES/NO
Time for drying buildings
Selection of the number of days, during which the system for drying buildings is
to be used exclusively with the instantaneous heating water heater.
With this setting, the heat pump will not start.
Heating will be implemented in accordance with the settings for set temperature
and switching times for standard and reduced mode (see operating instruc-
tions).
The "
0 " setting switches this function OFF.
The remaining days for drying buildings will be shown on the display when the
programming unit flap is closed.
Note
If the " Screed function " (see page 162) has been activated, no intervention
must occur here.
The settings under "
Screed function " are directly related to this setting. The
settings of both functions influence each other.
Access
&
" Device settings "
&
" Programming "
&
" Internal hydraulics "
&
"Time drying buildings" (
j
/
k
)
Standard setting 0
(function
"
OFF ")
Setting range 0 to 30 days
Heat pump for drying buildings
145
Internal hydraulics control settings
55
92
968
GB
Service