Viessmann VITOCAL 200-G, Инструкция по установке и обслуживанию

Страница: 66 / 208

6.
!
Please note
Putting the components of
the heat pump module and
the thermal insulation
under mechanical strain
can cause damage.
The heat pump module
must only be lifted beneath
the thermal insulation, at
the front edge of the bot-
tom plate or at the brace
(with lifting eye) located in
the middle of the unit.
Note
Position the heat pump mounts in
the four indentations
C
provided
for this purpose in the floor plate.
Lift the heat pump with the ther-
mal insulation into the equipment.
7. Only with BWP 106/400 V:
Push the compressor connection
into pos.
K
at the control module
(see page 19).
8. Push the safety chain connection
(4-pin plug with designation 1, 2,
3, 4) into pos.
E
at the control
module (see page 19).
Push the primary pump connec-
tion (3-pin plug with designation
PE, 5, 6) into pos.
D
at the con-
trol module (see page 19).
Note
The plugs must click home.
9. Push the primary temperature
sensor connection (2-pin, LV, see
illustration on page 65) into the
mating plug dangling from the
control panel.
10.
!
Please note
Damage to the insulation
of the electrical cables can
result in short circuits.
Route cables so that they
cannot touch very hot,
vibrating or sharp-edged
components. Secure
cables with cable ties.
Bundle the cables and secure
with cable tie below the control
panel. Fit transfer plugs at control
module with strain reliefs.
11. Check that the unit is horizontal,
re-adjusting the adjustable feet if
necessary (see page 55).
Installing the heat pump module and making the . . .
(cont.)
66
Installation sequence
55
92
968
GB