Vanderbilt SPC4 Series, Руководство по установке и настройке, Страница: 249 / 402

Quiet Mode Enable this setting to disable the buzzer during entry and exit when the
keypad is in an armed area.
NOTE: Keypad only audible for entry/exit/setting/unsetting if the area is the
same as the keypad location, or if the keypad is performing the operation.
Deactivation
Calendar Select if the keypad should be limited by calendar. See Calendars on
page 284.
Mapping gate Select if keypad should be limited by a mapping gate.
Keyswitch Select if keypad should be limited by a keyswitch.
PACE Entry Tick this box to disable the keys on the keypad during the entry time when a
PACE is configured on the keypad.
Areas
Location Select the secured area where the keypad is located.
Areas Select which areas can be controlled through keypad.
Options
Delay Fullset Select to configure a delayed set across all keypads. The location of the
keypad is ignored and all areas will perform a full exit time count down.
Keypad
Access
Level Select keypad access level (1 to 3).
Level 1 – All functions
Level 2 – Arm, disarm, and restore only
Level 3 – View only
NOTICE: An area should be assigned to a keypad only if the keypad is inside the assigned area, and
if an entry/exit route is defined. If an area is assigned, when the particular area is set or unset then
entry and exit timers are used (if configured). Other features related to entry/exit routes also become
available. If no area is assigned, the area is set or unset immediately and other entry/exit features are
not available.
17.10.2.3 Door Controllers
Editing a door controller
1. Select Configuration > Hardware > X-Bus > Door Controllers .
2. Click one of the blue marked data (for example, serial number).
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 249 A6V10276959-d
11.2018