Universal Laser Systems PLS3.60, Руководство по безопасности, установке, эксплуатации и базовому обслуживанию

Страница: 46 / 116

ASSEMBLING THE PLS
Section 4-2
1. Unpack the laser system from its packaging.
2. Remove the unassembled cart from the top of the laser system.
3. Assemble the cart as it appears in the diagram on the previous page but leave all of the screws
slightly loose except for the casters, which should be tightened as far as it can go into the cart leg.
4. With the assistance of three or four other people, place the system on top of cart and secure with the
screws provided.
5. Open front door all the way to ensure that it does not come in contact with the cart legs. If it does,
gently spread the legs apart. Securely tighten all the screws and re-check.
6. Attach your exhaust system’s flexible rubber hose to the exhaust port at the rear of the laser system
and secure with a hose clamp.
7. Locate the laser system in its final resting location.
8. Place a bubble level across the rear legs (1). Adjust the caster height using the adjustment screw (2)
until both the rear part and the front part of the legs are level with respect to each other. Once the
system is level, secure all casters by tightening the nut (3) up against the cart leg.
9. Open the top door and remove the rubber band that is holding the arm in place.
10. Remove any remaining packing materials, accessories or any other items that may be located inside
the cabinet or on top of the engraving table.
2
3
1
POWER POWER
PPI PPI
SPEED SPEED
COLOR COLOR