Universal Laser Systems PLS3.60, Руководство по безопасности, установке, эксплуатации и базовому обслуживанию

Страница: 85 / 116

ACCESSORIES
Section 8-9
cover 1/8 turn clockwise to lock it into place.
esiccant
Remove the metal cover by
ownward slowly. Pour out and discard old
er.
of the container.
Install metal cover and turn 1/8 turn until lever clicks into place.
Removal, Cleaning, and Replacement of the Filter
•
Turn the Air Compressor OFF and unplug it.
•
Unscrew the cover by turning it 1/8 turn counterclockwise
like you were unscrewing a jar, and pull down. The clear
plastic container might still remain attached to the top.
Gently pull this part straight down.
•
You will see a red colored foam filter. Unscrew the filter,
and wash it out with water. Make sure that it is completely
dry, then reinstall.
•
Empty and clean out any residue or dust that may have
accumulated on the bottom of the clear plastic container.
•
Install the clear plastic container into the cover and line up
the tabs so that they fit one inside of the other.
•
Insert the combination of the cover and the clear plastic
container into the top of the assembly. Gently twist the
Removal, Cleaning, and Replacement of the D
•
Turn the Air Compressor OFF and unplug it.
•
Pull down on black lever and rotate metal cover 1/8
turn counterclockwise.
pulling it straight down.
•
With a gentle and slight twisting motion, pull the clear
container d
desiccant.
•
Refill clear container with fresh desiccant from a
sealed bag. Fill to about ¼ inch from top of contain
•
Clean off rubber o-ring on the top
•
Insert container up into the top.
•
Dual Head
The Dual Head option was created to enhance productivity when engraving large quantities of the same
item providing that two or more of the same item fit within the horizontal engraving area (X-axis) of your
laser system. The Dual Head option can significantly reduce your overall engraving time if you divide the
total processing time by the quantity of items engraved, however, there are limitations involved when
sing this option.
as fast” than engraving with a single head. Typical productivity increases may vary
e applications, using the Dual Head option may reduce efficiency than engraving with a single
o compensate for
the difference by adjusting the spacing between your objects in the engraving area.
u
•
It is not “twice
from 25-75%
•
In som
head.
•
There is an overall laser power loss due to additional optics ranging from 1% - 5%.
•
The beam is not split EXACTLY 50/50 although it is close enough for most applications.
•
Because of optical angles and the effect of passing the beam through splitting optics, the engraving
field most likely WILL NOT be split EXACTLY in half. There may be a small tolerance in absolute
beam positioning by as much as +/- 1/16
th
of an inch. In this case, you would need t