Universal Laser Systems PLS3.60, Руководство по безопасности, установке, эксплуатации и базовому обслуживанию

Страница: 48 / 116

ASSEMBLING THE PLS
Section 4-4
5. Slowly rotate the laser cartridge making
sure that the alignment plate is centered in
the gap of the alignment fork between the
small and large plates. As you slowly
release the weight of the laser, you should
feel it lock (clunk sound) itself smoothly into
place, parallel to the mounting surface.
NEVER FORCE THE LASER INTO
POSITION. If the laser does not install
smoothly, check for obstructions such as
pinched wires or hoses or a binding laser
latch. Once installed, verify that the
alignment plate is centered within the
alignment fork. 6. Plug in the power connector (1). Slowly
close the rear cover and
making sure that
wires or hoses do not become pinched
when the cover is closed.
Push down on
the latches until they “click”.
Proceed to Section 4-8 once the laser tube has been installed.
System Assembly - PLS6.60 and PLS6.120D
Unpack the laser system from its packaging.
If the doorway is not wide enough to allow to you roll the laser system through it, the system
MUST be
detached from the cart stand, rotated sideways, passed through the doorway, then re-attached to the cart
stand (Section 4-5).
If your doorway is wide enough, you can skip the following procedure and proceed to “Leveling the
System” (Section 4-6). It would help if you had a
PADDED floor dolly to transport the machine through
the doorway. If one is not available, it will need to be carried through the doorway.
The laser system without the cart stand weighs approximately 200 lbs.
Obtain assistance from as many people as possible (3 or 4 people). Always
use a back-support device when lifting. Do not attempt lifting the machine if
you are physically handicapped or are injured in any way. Seek the advice of
a physician if you are unsure.