Universal Laser Systems PLS3.60, Руководство по безопасности, установке, эксплуатации и базовому обслуживанию

Страница: 71 / 116

Section 7
Basic Maintenance
Keeping the laser system clean will ensure the highest quality engraving. The frequency of cleaning will
depend entirely on the type of material being engraved, the performance of your exhaust system, the
operating environment, and the amount of laser system usage over a given period of time. Dirt or debris
that is allowed to build up on the motion system components will cause uneven or rough engraving, or
loss of engraving position as well as premature component failure. Smoke or dirt buildup on the optics
can cause damage to them, loss of laser power, or premature failure of these components. Use good
judgment and keep in mind that a clean machine is the best performing machine. Always turn the laser
engraving system OFF and unplug it before performing any cleaning procedures.
Motion System Components Diagram
NOTE: #2 Mirror Cover and
X-axis Motor Cover Plates
have been removed for visibility.
1) Focus
carriage
3
10
7
8
9
1
2
4
5
6
11
12
13
14
15
16
17
18
19
20
21
18
22
23
14
16
2) X-axis bearing (3)
3) #3 mirror (inside cover plate)
17) Y-axis drive gear (2) (one on right side, one on left side)
18) Y-axis shaft (2) (one on right side, one on left side)
19) Y-axis shaft flex coupler (one on right side, one on left side)
20) Y-axis motor
21) Y-axis idler pulley (2) (one on right side, one on left side)
22) Y-axis home sensor flag
23) Flex cable
4) Focus lens (inside cover plate)
5) X-axis
rail (arm)
6) X-axis bearing track (2)
7) X-axis
belt
8) X-axis home sensor flag
9) X-axis idler pulley
10) #2 mirror and holder
11) X-axis motor and drive gear
12) X-Y home sensor board (upper flex board)
13) Y-axis belt (2)
14) Y-axis bearing (4) (2 on right side Y-axis rail, 2 on left side Y-axis rail)
15) Y-axis rail (2)(one right side and one left side)
16) Y-axis rail bearing track (2) (one on right side, one on left side)