Telescopic spindle - Variant 1
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
95
Adjusting the spindle
(see chapter 24.1 on page 262).
Place the telescopic spindle on a firm surface and manually
pull the toothed belt pulley clockwise until you see the first
color marking on the spindle.
4. Note the correct installation position. Do not turn the telescopic
spindle into itself any further. Using both hands, securely grasp
the spindle at the spindle tube and bearing shell.
Hold the spindle in the installation position (make sure the
toothed belt is in right direction) and slide it to the end stop in
the column shaft.
Mount the telescopic in the column shaft (6 screws).
6. Rotate the bearing shell back into the installation position and
manually pull the toothed belt clockwise until the bearing shell
rests on the floor plate.
7. Attach the bearing shell to the floor plate (4 screws).
8. Install the lift motor (see chapter 15.6 on page 115). The teeth
of the pinion and of the toothed belt must interlock exactly!
Take note of the toothed belt tension!
9. Attach the subfloor cover (4 screws).
10. Safety note: The operating table is extremely heavy; take extra
care not to strain your back while righting it. A second person
is needed to right the operating table. Clear the floor in front
of the operating table and clean it if necessary. Right the
operating table with the help of a second person.
2.
CAUTION
Risk of material damage!
The spindle should never travel under motorized power to
either of the mechanical end stops. During adjustment, the
spindle is set such that the lifting function stops before reaching
the mechanical end stops.
3.
CAUTION
Risk of material damage if spindle adjustment is
lost!
Hold the spindle tube securely to maintain the adjustment.
When the spindle tube turns, the inner and outer spindles do
not rotate in or out equidistantly, making readjustment
necessary.
5.
CAUTION
Risk of material damage if spindle adjustment is
lost!
When you release the bearing shell, pay attention to the
direction in which it turns.
Содержание TruSystem 7000
