Calibrate lift motor
268
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
24.7
Calibrate lift motor
The motor level position is set using the CAN test center. Follow the
software description from the CAN test center.
1. Establish a communication connection to the CAN test center
(PC).
2. Open the bellows and secure above.
3. Open top column covers and guide downward.
4. Place the gauge #1729967 [1] on the lowest guide
block [2], and slowly move the column downward until the
suspension plate [3] is at the upper end of the gauge. If
needed, raise the column upward a bit so that the gauge can
be inserted. Important: do not travel to the mechanical end
stop.
5. On the "Target value" task card, press the "Set values" button
for "Position offset".
6. Reset (restart) the drive.
7. Check the end positions of the table top.
8. Close the connection to the operating table.
Содержание TruSystem 7000
