Trumpf TruSystem 7000, Руководство по обслуживанию

Страница: 181 / 306

Ground wire_24
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
181
20.1 Ground wire_24
Disassembly 1. Prepare the operating table (see chapter 7 on page 29).
2. Switch off the operating table and disconnect the internal
power supply (see chapter 10 on page 33).
3. Remove the pad plate of the seat section (see chapter 12.2 on
page 40). Important: keep the back section pad plate
attached so that the bar adjustment is retained.
4. Remove the cover from the center box (see chapter 12.3 on
page 41).
5. Be sure to note the cable routing.
Remove ground wire_24 [1] from the center box [2] and the
inside of the bar [3] (each with 1 screw with 2 washers).
6. Be sure to note the cable routing.
Unfasten ground wire_24 [1] from the center box [2] up to the
inside of the bar [3].
7. Remove the energy chain [4] (chain connection [5]) from the
center box [2] (2 screws).
8. Attach a wire pull to the end of ground wire_24.
9. Lay the energy chain straight and carefully pull ground
wire_24 out of the energy chain.
10. Remove ground wire_24 from the wire pull.
Assembly 1. Attach a wire pull to one end of ground wire_24. Use the wire
pull on the mounted end of the energy chain.
2. Straighten the energy chain and carefully pull the wire pull with
the ground wire through the energy chain without twisting.
3. Disconnect ground wire_24 from the wire pull and restore the
energy chain to its original position.
4. Restore the original cable routing.
Attach ground wire_24 to the center box and the inside of the
bar (each with 1 screw with 2 washers).
5. Pull ground wire_24 in the energy chain evenly taut.
6. Attach the energy chain (chain connection) to the center box
(2 screws).
7. Restore the original cable routing.
Refasten ground wire_24 from the center box up to the inside
of the bar.
8. Attach the cover to the center box (see chapter 12.3 on
page 41).
9. Attach the pad plate to the seat section bars (see chapter 12.2
on page 40).