Trumpf TruSystem 7000, Руководство по обслуживанию

Страница: 130 / 306

Tilt right motor
130
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
15.11 Tilt right motor
Important: assembly requires serial number. Note chapter 27 on
page 276.
Disassembly 1. Prepare the operating table (see chapter 7 on page 29).
2. Switch off the operating table and disconnect the internal
power supply (see chapter 10 on page 33).
3. Remove the table top (see chapter 12.1 on page 38).
4. Remove the bellows (see chapter 14.3 on page 78).
5. Grasp the column cover, remove the holding screw from the
Trendelenburg assembly and guide the cover carefully
downward.
6. Open the column cover at the top and slide it down (see
chapter 9 on page 31).
7. Remove the metal panel with the column keypad (see
chapter 14.2 on page 77).
8. Remove the tilt right assembly (see chapter 15.8 on
page 122).
9. Remove the toothed belt [1] and toothed belt pulley [2] from
the tilt drive (see chapter 14.6 on page 84).
10. Grasp the motor [4] securely and note the installation position
of the connector on the motor.
Remove the 4 screws from the motor mounting bracket [3] and
pull the motor [4] down out of the plate.
Assembly 1. Address the motor (see the software description from the CAN
test center).
2. Note the original installation position of the motor and the
connector on the motor.
From below, carefully insert the motor in the plate and mount it
to the motor mounting bracket (4 screws).
3. Mount the toothed belt pulley and toothed belt on the tilt drive
and tighten the toothed belt (see chapter 14.6 on page 84).