Trumpf TruSystem 7000, Руководство по обслуживанию

Страница: 105 / 306

Toothed washer of the telescopic spindle
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
105
8. Install the lift motor (but do not tighten the screws yet).
9. Tighten the toothed belt:
a) Check the toothed belt tension with a belt tension meter.
The value must be 140 Hz (±5 Hz). If necessary, adjust the
toothed belt tension with the tensioning screw (hexagonal
screw).
b) Tighten the screws on the lift motor mounting bracket with 7
Nm (4 screws).
c) Check the toothed belt tension and reset if there are
differences. The value on the belt tension meter must be
140 Hz (±5 Hz).
10. Attach the subfloor cover (4 screws).
11. Safety note: The operating table is extremely heavy; take extra
care not to strain your back while righting it. A second person
is needed to right the operating table. Clear the floor in front
of the operating table and clean it if necessary. Right the
operating table with the help of a second person.
12. Remove the multifunction tool.
13. Remove the toothed wheel.
14. Establish the internal power supply, close the column cover
and turn on the operating table (see chapter 10 on page 33).
15. Lock operating table (brake)
16. Put on the pad.
17. Calibrate the lift motor (CAN test center). See chapter 24.7 on
page 268.
18. Update the software (see the software description from the
CAN test center).
TEST
Perform function test and final check.