Trumpf TruSystem 7000, Руководство по обслуживанию

Страница: 39 / 306

Table top
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
39
in the center box. They align with the openings in the mounting
plate.
2. Route cables W164, W173, the cable adapter
2)
, and
sensor cable upward through the opening into the center box.
3. Check the insulating foil of the motor controller circuit board/
communication processor in the center box and replace it if
damaged.
4. Insert the cable adapter plug
2)
into the socket on the
underside of the motor controller circuit board.
5. Insert and install the motor controller circuit board in the center
box (3 screws).
6. Insert and install the communications controller circuit board in
the center box (4 screws).
Restore the original cable routing.
Connect all the plugs to the motor controller circuit board and
the communication processor circuit board.
8. Attach the cover to the center box (see chapter 12.3 on
page 41).
9. Attach the pad plate to the seat section bars (see chapter 12.2
on page 40).
10. Establish the internal power supply, close the column cover
and turn on the operating table (see chapter 10 on page 33).
11. Put on the pad.
7.
CAUTION
Risk of material damage due to incorrect connector
pin assignment!
Do not interchange the connectors on the circuit board.
Follow the circuit diagram on page 295.
TEST
Perform a function test.