Trumpf TruSystem 7000, Руководство по обслуживанию

Страница: 211 / 306

Cable W164
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
211
15. Remove the cable deflector [13] from the power supply
unit [14]. To do this, unscrew the 2 screws [16] at the top of
the power supply unit [14] and loosen the two screws [15] on
the column base. Guide the cable deflector out of the
screws [15] on the column base and remove it.
16. Note the cable routing and attachment.
Unfasten cable W164 [4] from the column base.
17. Unplug cable W164 [4] from the power supply circuit
board [17] in the power supply socket.
18. Remove the lower spiral cable holder [18] next to the lift
motor [19] from the column base (1 screw).
19. Remove cable W164.
Assembly 1. Attach the upper spiral cable holder of cable W164 to the tilt
left assembly (2 screws).
2. Attach the lower spiral cable holder next to the lift motor on the
column base (1 screw). Make sure that the cylindrical pin on
the column base sits in the cut-out in the holder.
3. Insert the plug of cable W164 into the socket on the connector
board (ST2) (power supply socket) (see circuit diagram on
page 295).
4. Restore the original cable routing. Note the shield support.
Refasten cable W164 to the column base.
5. Set the cable deflector onto the two screws on the column
base and slide it flush against the power supply unit. Mount the
cable deflector to the power supply unit (2 screws on the top)
and tighten the two screws on the column base.