Trumpf TruSystem 7000, Руководство по обслуживанию

Страница: 166 / 306

Locking cylinder with hose
166
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
18.5 Locking cylinder with hose
Disassembly 1. Prepare the operating table (see chapter 7 on page 29).
2. Secure the star wheel (#1800121) on the right side rail
15)
of
the seat section.
3. Lift the cover plate on the table base above the wheel.
Release the brake on the operating table (unlock the
operating table).
Attention: The quick connectors on the assembly can be
loosened and connected only if the floor locks of the wheels
are retracted, thereby relieving the hydraulic system. If
necessary, press the E
MERGENCY RELEASE
button.
5. Switch off the operating table and disconnect the internal
power supply (see chapter 10 on page 33).
6. Slide the multifunction tool [1] mounted as a T under the table
base [2].
7. Safety note: The operating table is extremely heavy; take extra
care not to strain your back when turning it on its side. A
second person is needed to turn the operating table on its side.
With the help of another person, lay the operating table over
onto the multifunction tool (side with the column keypad points
up) and set it on the star wheel.
Do not place the operating table on its side with the column
keypad pointing down. In this case, air would get into the
hydraulic hoses when the hydraulics were activated.
8. Remove the snap ring [3] from the floor lock [4] and pull off the
wheel [5].
15)
Side without the column keypad
4.
CAUTION
Risk of material damage!
The major force required to turn the table on its side can break
the extended foot locks of the brake. The operating table must
be unlocked before turning it on its side.