Coil on the pump assembly
164
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
9. Using a flat screwdriver, alternating at each corner, carefully
lift the coil [5] (in the magnet housing [6]), from the
assembly [4]. If necessary, hit a plastic hammer against the
screwdriver.
10. Note the mounting position of the coil in the magnet housing.
Remove the coil [5] from the magnet housing [6].
11. Measure the resistance at the coil with a multimeter. The value
must be 66
±6
ohm. In case of error replace the coil.
Assembly
1. Insert the coil into its original position in the magnet housing.
2. There has to be a gap of between 0.5 mm and 1 mm between
the magnet housing and the assembly (use a thickness gauge).
Carefully hammer the coil (in the magnet housing) onto the
assembly using a plastic hammer.
3. Connect the plug to the coil.
4. Position the assembly in its mounting position in front of the
table base.
5. Restore the original cable routing. Check all connections on
the assembly to be sure they are secure.
Carefully insert the cover with the assembly into the table base
and mount it (4 screws with washers).
6. Establish the internal power supply and perform a function test.
Lock and release the operating table using the CAN test
center. Make sure the floor locks retract after the procedure
(necessary to right the table). Then disconnect the internal
power supply.
7. Safety note: The operating table is extremely heavy; take extra
care not to strain your back while righting it. A second person
is needed to right the operating table. Clear the floor in front
of the operating table and clean it if necessary. Right the
operating table with the help of a second person.
8. Remove the multifunction tool.
9. Remove the toothed wheel.
10. Check the label over the
E
MERGENCY
RELEASE
button and
replace if damaged (for example due to triggering the button).
11. Establish the internal power supply, close the column cover
and turn on the operating table (see chapter 10 on page 33).
12. Lock operating table (brake)
Содержание TruSystem 7000
