Trumpf TruSystem 7000, Руководство по обслуживанию

Страница: 288 / 306

Troubleshooting
288
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
No movement during a motor-
driven operating table function.
Motor not running (no audible
motor noises).
Motor is not or incorrectly
addressed
Set the motor parameters using
the CAN test center. Update
software.
Power supply to motor interrupted. Check cable position and
connections and establish
connections as needed.
Motor is defective. Check the motor through the
CAN test center. If voltage has
been applied and communication
with the motor is possible, the
motor is defective. Replace motor.
Check the motor through the
CAN test center. If communication
with the motor is not possible, the
motor is defective. Replace motor.
Spindle is stuck. Replace spindle.
OR sensor is active without OR
adapter. As a result, longitudinal
travel can be blocked.
Check the OR sensor through the
CAN test center. If the longitudinal
travel motor can operate through
the CAN test center, the OR
sensor is defective. Replace OR
sensor.
No movement during a motor-
driven operating table function.
Motor is running (audible motor
noises).
Toothed belt tension is incorrect. Tighten the toothed belt.
Spindle or toothed belt is
defective.
Check the spindle or toothed belt
for visible damage and replace.
No movement during tilt and
Trendelenburg functions.
Column controller is defective. Check the column controller
through the CAN test center.
Replace column controller.
No synchronous drive movement. Motor values are incorrect. Angle
deviation between both drives. If
there is a difference greater than
3° the drives cannot run
synchronously.
Use the CAN test center to move
the drives until the difference in
position is less than 3°. Set the
motor parameters using the CAN
test center. Update software.
Replace gear.
Error Possible cause Correction