Trumpf TruSystem 7000, Руководство по обслуживанию

Страница: 248 / 306

Cable W177
248
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
8. Unplug cable W177 [4] from the small filter [6] (1A).
9. Unplug the other end of cable W177 [4] from the control
module [5].
10. Note the cable routing and attachment.
Unfasten cable W177 [5] from the filter [6] up to the control
module [5] and remove cable W177.
Assembly 1. Restore the original cable routing.
Route cable W177 in the table base.
2. Insert the plug of cable W177 into the socket on the control
module (see circuit diagram on page 295).
3. Plug the plug at the other end of cable W177 into the small
filter (1A) (see circuit diagram on page 295).
4. Refasten cable W177 from the filter up to the control module.
5. Mount the cover above the control module (4 screws).
6. Safety note: The operating table is extremely heavy; take extra
care not to strain your back while righting it. A second person
is needed to right the operating table. Clear the floor in front
of the operating table and clean it if necessary. Right the
operating table with the help of a second person.
7. Remove the multifunction tool.
8. Remove the toothed wheel.
9. Establish the internal power supply, close the column cover
and turn on the operating table (see chapter 10 on page 33).
10. Lock operating table (brake)
11. Put on the pad.
TEST
Perform recheck according to IEC 60601-1; perform function test
and final check.