Trumpf TruSystem 7000, Руководство по обслуживанию

Страница: 168 / 306

Locking cylinder with hose
168
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
3. Position the assembly in its mounting position in front of the
table base.
4. Tighten the clamp on the quick connector and connect the
hydraulic hose to the assembly (quick connectors) (see
chapter 23 on page 260 and hydraulic diagram on page
299).
5. Restore the original cable routing. Check all connections on
the assembly to be sure they are secure.
Carefully insert the cover with the assembly into the table base
and mount it (4 screws with washers).
6. Establish the internal power supply and perform a function test.
Lock and release the operating table repeatedly using the
CAN test center. Make sure the floor locks retract after the
procedure (necessary to right the table). Then disconnect the
internal power supply.
7. Slide the wheel onto the floor lock up to the stop.
8. Secure the spring ring in the groove of the floor lock.
9. Safety note: The operating table is extremely heavy; take extra
care not to strain your back while righting it. A second person
is needed to right the operating table. Clear the floor in front
of the operating table and clean it if necessary. Right the
operating table with the help of a second person.
10. Remove the multifunction tool.
11. Remove the toothed wheel.
12. Remove any adhesive residue from the table base above the
wheel and degrease.
13. Affix a new cover plate above the wheel on the table base.
14. Check the label over the
E
MERGENCY RELEASE
button and
replace if damaged (for example due to triggering the button).
15. Establish the internal power supply, close the column cover
and turn on the operating table (see chapter 10 on page 33).
16. Lock operating table (brake)
17. Put on the pad.
TEST
Perform recheck according to IEC 60601-1; perform function test
and final check.