Trumpf TruSystem 7000, Руководство по обслуживанию

Страница: 67 / 306

Back section motor
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
67
13.7 Back section motor
Important: assembly requires serial number. Note chapter 27 on
page 276.
Disassembly 1. Prepare the operating table (see chapter 7 on page 29).
2. Switch off the operating table and disconnect the internal
power supply (see chapter 10 on page 33).
3. Remove the pad plate of the seat section (see chapter 12.2 on
page 40).
4. Remove the pad plate of the back section (see chapter 12.2
on page 40).
5. Remove the drive unit of the back section (see chapter 13.6 on
page 65).
6. Pay particular attention to the installation position of the motor
and to the feather key.
Release the ring nut on the motor [2] with a hook wrench and
pull the motor [2] out of the gear box [1].
Assembly 1. Address the new motor (see the software description from the
CAN test center).
2. Make sure to re-install the motor in its original position.
Align the lugs on the motor flange with the recesses on the
gear box (connection sockets on the motor are on top), rotate
the motor shaft until the feather key lines up with the slot in the
gear box, precisely insert the key into the slot of the motor shaft,
and then slide the motor into the gear box up to the end stop.
3. Tighten the ring nut on the motor and fixate the connection with
screw coating (#4150041) (at least three application points
evenly distributed across the diameter.)
4. Attach the back section drive unit to the back section bar (see
chapter 13.6 on page 65).
5. Calibrate the back section motor (CAN test center). See
chapter 24.4 on page 266.
6. Align the bars (see chapter 24.2 on page 265).
7. Attach the pad plate to the seat section bars (see chapter 12.2
on page 40).
8. Attach the pad plate to the back section bars (see
chapter 12.2 on page 40).