Trumpf TruSystem 7000, Руководство по обслуживанию

Страница: 195 / 306

OR sensor
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
195
20.9 OR sensor
Disassembly 1. Prepare the operating table (see chapter 7 on page 29).
2. Switch off the operating table and disconnect the internal
power supply (see chapter 10 on page 33).
3. Remove the pad plate of the seat section (see chapter 12.2 on
page 40). Important: keep the back section pad plate
attached so that the bar adjustment is retained.
4. Remove the cover from the center box (see chapter 12.3 on
page 41).
5. Remove plug of sensor cable [1] from the longitudinal travel
motor [2].
6. Note the cable routing and attachment.
Remove the cable attachment along the sensor cable from the
sensor [3] to the longitudinal travel motor [2].
7. Remove the cover over the OR sensor from the center box (foot
end - 4 screws).
8. Remove the sensor cable [1].
Assembly 1. Lay the sensor in the cut-out in the center box.
2. Attach the cover over the OR sensor on the center box (4
screws).
3. Restore the original cable routing.
Lay the sensor cable in the center box and reattach the cable
attachment.
4. Plug the sensor cable plug into the longitudinal travel motor
(see circuit diagram on page 295).
5. Attach the cover to the center box (see chapter 12.3 on
page 41).
6. Attach the pad plate to the seat section bars (see chapter 12.2
on page 40).
7. Establish the internal power supply, close the column cover
and turn on the operating table (see chapter 10 on page 33).
8. Put on the pad.
TEST
Perform recheck according to IEC 60601-1; perform function test
and final check.