Trumpf TruSystem 7000, Руководство по обслуживанию

Страница: 176 / 306

Assembly with valve block
176
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
Carefully hammer the coil (in the magnet housing) onto the
assembly using a plastic hammer.
4. Mount the spacer plate on the assembly (2 screws).
5. Mount the assembly with the spacer plate on the cover (4
screws).
6. Position the jack unit in its installation position in front of the
table base.
7. Insert the motor cable plug into the socket on control module
(see circuit diagram on page 295).
8. Insert all plugs into the sockets on the assembly (see circuit
diagram on page 295).
9. Tighten the clamps on the quick connectors and connect all
hydraulic hoses on the assembly (quick connector) (see
chapter 23 on page 260 and hydraulic diagram on page
299).
10. Restore the original cable routing. Check all connections on
the jack unit to be sure they are secure.
Carefully insert the cover with the assembly into the table base
and mount it (4 screws with washers).
11. Mount the cover above the control module (4 screws).
12. Safety note: The operating table is extremely heavy; take extra
care not to strain your back while righting it. A second person
is needed to right the operating table. Clear the floor in front
of the operating table and clean it if necessary. Right the
operating table with the help of a second person.
13. Remove the multifunction tool.
14. Remove the toothed wheel.
15. Check the label over the
E
MERGENCY RELEASE
button and
replace if damaged (for example due to triggering the button).
16. Establish the internal power supply, close the column cover
and turn on the operating table (see chapter 10 on page 33).
17. Lock operating table (brake)
18. Put on the pad.
TEST
Perform recheck according to IEC 60601-1; perform function test
and final check.