THOMSON Grass Valley Kalypso Classic, Справочное руководство

Страница: 302 / 404

302 Kalypso Reference Manual
Section 3 — Menus
Path Controls
The path control pane is located to the right of the data pad delegation
matrix.
S Linear
,
Linear
, and
Curve
interpolation touch buttons are available.
When
Curve
is selected, soft knob controls for
Tension
,
Continuity
, and
Bias
soft
knob become available. You can also turn off transform interpolation and
hold each keyframe’s values with the
Path Hold
touch button.
To specify a path for a transform, select the category of transform with the
data pads at the lower area of the screen. Then select the path type in the
upper middle pane, which will be labeled with that transform category.
When
Curve
is selected, use the soft knobs or associated data pads to enter
values for tension, continuity, and bias.
All transforms except
Spin
apply the same path control to all that trans-
form’s parameters.
Spin
allows different paths to be specified for each axis
of the transform. When
Spin
is selected, the
X
,
Y
,
Z
, and
All
touch buttons are
activated. The selected path will only be applied to the specified axis.
Clear Transforms
Two buttons located on the lower right side of the Transform Engine menu
(
page 299 ) are used to clear transform settings.
Clear Xfms
– Sets all transform parameters of the delegated keyer (or global
channel) to Default Keyframe values. The transform parameters reside in
the panels below the data pad delegation matrix, and do not include Crop.
Clear All
– Sets all transform parameters and all other menu settings,
including Crop values, of the delegated keyer to Default Keyframe values.