Teledyne RD Instruments SENTINEL V REAL-TIME, Руководство по эксплуатации

Страница: 215 / 343

Sentinel V SC and RT Operation Manual
September
2017
EAR-Controlled Technology Subject to Restrictions Contained on the Cover Page.
Page 199
Control System Commands
The Sentinel V Real-Time uses the following commands to control certain system parameters.
Available Control System Commands
This section lists the available Control System commands.
>c?
Available Commands:
CB 811 ------------------ Serial Port Control {baud;parity;stop}
CF 11110 ---------------- Set Ctrl Flags {e;p;b;s;*}
CK ---------------------- Save Command Parameters to Flash
CN ---------------------- Network Configuration Menu [0=help]
CR ---------------------- Restore Cmd defaults [0=user,1=factory]
CS ---------------------- Start Pinging
CSTATE ------------------ Pinging State Query
CSTOP ------------------- Stop Pinging
CT 1 -------------------- Turnkey (0 = OFF, 1 = ON)
CU 0 -------------------- Set Update Mode (0 = OFF, 1 = ON)
CW ---------------------- Output the Last Stored Ensemble
C? ---------------------- Display C-Command Menu
>#C?
*** CAUTION: These commands are reserved for RDI use
and may not be currently supported!
Available Commands:
#CC --------------------- Update global variables with S&P C&C Data
#CG 1 --------------- Set Beam Matrix output frequency ([1-65535] ensembles)
#CR --------------------- Reboot System
#CM --------------------- Set System Communication Mode
#C? --------------------- Display C-Command Menu
>
Control System Command Descriptions
CB – Serial Port Control
Purpose Sets the RS-232/422 serial port communications parameters (Baud Rate/Parity/Stop Bits).
Format CBnnn
Range nnn = baud rate, parity, stop bits (see description)
Default CB411
Recommended Setting. The default setting for this command is recommended for most applications.
Description The Sentinel V Real-Time and the computer MUST use the same communication parame-
ters to talk to each other. After a valid CB parameters are entered, the Sentinel V Real-Time
responds with a “>” prompt. Then change the external device’s communication parameters
to match the Sentinel V Real-Time parameters before sending another command.