TAKASAGO ZX-S-H Series, Инструкция по эксплуатации

Страница: 107 / 192

Using via Digital Data Communication
------------------------------------------------------------------------------------
103
SET Commands
This section explains the SET commands of EX based commands.
Ａ
：Assigns Device Address
Function：Assigns the device address for ZX power supplies
Format：Ａ＊ ＊：Set value within range
Range：０～５０
Assigned Address 0 is a global address. Assign addresses to all multi-connected ZX-S Series power
supplies.
Once the global address is assigned, only Output ON/OFF Toggle SET command “OT” is valid.
Further, no Acknowledge Responses will be sent only while the global address is assigned
＜Ex.＞A1 /* Assigns address 1 to ZX power supply */
＜Ex.＞A1,OT1,A2,OT1 /* Errors due multple address assignment commands */
ＡＲ
：Executes Alarm Reset
Function：Executes alarm reset (cancels triggered OVP/OCP alarms)
Format：ＡＲ＊ ＊：Set value
Set value：
１：Resets alarms
Values other than 0 and 1 result in parameter errors. (0 does nothing)
＜Ex.＞A1,AR1
ＣＬ
：Resets Set Parameters
Function：Resest the set parameters
Format：ＣＬ＊ ＊：Set value
Set Value：
１：Resest to factory default settings
Values other than 0 and 1 result in parameter errors. (0 does nothing)
＜Ex.＞A1,CL1
Do not set redundant ZX power supply addresses within the same system.
Further, only one address can be assigned per send. Assigning multiple addresses at once is not
possible.
Caution

Execute alarm reset only once cause has been resolved.
Caution
