Suzuki UG110 2021, Руководство по обслуживанию

Страница: 72 / 198

ENGINE 3-43
• Tighten the final gear oil drain bolt
1
to the specified torque.
"
Final gear oil drain bolt: 12 N.m (1.2 kgf.m)
• Add final gear oil until it flows from the final gear oil level hole
2
.
4
Final gear oil quantity: 130 ml
• Tighten the final gear oil level bolt to the specified torque.
"
Oil level bolt: 12 N.m (1.2 kgf.m)
DRIVE BELT
• Insert the drive belt, as low as possible, between the clutch
shoe/movable driven face while pulling out the driven face to
provide the maximum drive belt clearance.
5
* The drive belt should be installed so that the arrows
on the drive belt periphery point in the normal turning
direction.
* The drive belt contact surface of the driven face should
be thoroughly cleaned.
• Thoroughly clean the clutch housing and position it over the
clutch shoe assembly.
• Tighten the clutch housing nut to the specified torque using the
special tool.
2
09930-40113: Rotor holder
"
Clutch housing nut: 50 N.m (5.0 kgf.m)
• Install the movable drive face assembly
1
and spacer
2
onto
the crankshaft, as shown.
NOTE:
Thoroughly clean the drive belt contact surface.
• Install the wave washer
3
as shown.