Suzuki UG110 2021, Руководство по обслуживанию

Страница: 66 / 198

ENGINE 3-37
ENGINE REASSEMBLY
Reassemble the engine in the reverse order of disassembly. The
following steps require special attention or precautionary mea-
sures should be taken.
NOTE:
Apply engine oil to each running and sliding part before reas-
sembling.
CRANKSHAFT
• Mount the crankshaft into the right crankcase by pulling its right
end into the crankcase using the special tools.
2
09910-32812: Crankshaft installer
09910-20116: Conrod holder
5
Never fit the crankshaft into the crankcase by striking it
with a plastic hammer. Always use the special tools, oth-
erwise the crankshaft may be misaligned.
CRANKSHAFT SHIM SELECTION
• After mounting the crankshaft into the right crankcase, mea-
sure the length
A
between the right crankcase end and left
end of the crank web.
• Measure the length
B
between the left crankcase end and left
crankshaft bearing.
• Decide the proper shim thickness by the following clearance
C
as shown below.
(
B
–
A
) – 0.05 mm = Clearance
C
0.05 mm: Inner race play of the left crankshaft bearing
Clearance
C
(mm) Shim thickness (mm) Part No.
0.60 – 0.65 0.60 09181-30037
0.65 – 0.70 0.65 09181-30038
0.70 – 0.75 0.70 09181-30039
0.75 – 0.80 0.75 09181-30040
0.80 – 0.85 0.80 09181-30041
0.85 – 0.90 0.85 09181-30042
0.90 – 0.95 0.90 09181-30164
0.95 – 1.00 0.95 09181-30165
1.00 – 1.05 1.00 09181-30045
1.05 – 1.10 1.05 09181-30046
1.10 – 1.15 1.10 09181-30047
1.15 – 1.20 1.15 09181-30048
1.20 – 1.25 1.20 09181-30049
1.25 – 1.30 1.25 09181-30050