Suzuki UG110 2021, Руководство по обслуживанию

Страница: 112 / 198

5-16 CHASSIS
BRAKE PADS REPLACEMENT
• Remove the brake caliper mounting bolts
1
.
• Remove the clip
2
and brake pad mounting pin
3
.
• Remove the brake pads
4
.
5
Do not operate the front brake lever while removing the
pads.
• Install the new brake pads.
• Tighten the brake caliper mounting bolts
5
to the specified
torque.
"
Brake caliper mounting bolt: 26 N.m (2.6 kgf.m)
NOTE:
After replacing the brake pads, pump the brake lever a few times
to make sure the brake operates correctly and then check the
brake fluid level.
BRAKE FLUID REPLACEMENT
• Place the motorcycle on a level surface and keep the handle-
bars straight.
• Remove the wind screen. (
7
5-32)
• Remove the master cylinder reservoir cap and diaphragm.
• Suck up the old brake fluid as much as possible.
• Fill the reservoir with fresh brake fluid.
,
Specification and classification: DOT 4
Measure the thickness
A
of the brake pads. If the brake pad thick-
ness is below the service limit, replace the brake pads with new
ones.
4 4 4 4 4
Brake pad thickness
A
Service Limit: 0.5 mm
5
Replace the brake pads as a set, otherwise braking per-
formance will be adversely affected.