Sun Microsystems SunLink SNA 9.1 PU2.1, Руководство по настройке

Страница: 69 / 298

Getting Started 3-3
3
4. Install the Sun Gateway Manager (SunGMAN) and Sun Graphical
Management Interface (SunGMI) software. Refer to the appropriate Sun
PU2.1 SNA Server Planning and Installation Guide.
5. Install the Sun PU2.1 SNA Server software on the system that contains the
communication hardware that connects to your IBM SNA environment.
Refer to the appropriate Sun PU2.1 SNA Server Planning and Installation
Guide.
6. Create a configuration, if necessary. Refer to Section 3.4, “Creating a
Configuration,” on page 3-4.
7. Configure the system. Refer to Section 3.4.2, “Configuring a System,” on
page 3-5.
8. Add a PU2.1 server. Refer to Section 3.4.3, “Adding a PU2.1 Server,” on
page 3-6.
9. Add the appropriate connection. Refer to Section 3.4.4, “Adding a
Connection,” on page 3-7.
10. Add a PU. Refer to Section 3.4.5, “Adding a PU,” on page 3-10.
11. Add a dependent LU. Refer to Section 3.4.6, “Adding a Dependent LU,”
on page 3-11.
12. Save the configuration. Refer to Section 3.4.7, “Saving the New
Configuration,” on page 3-13.
13. Install the appropriate Sun SNA clients. Refer to the appropriate Sun
PU2.1 SNA Server Planning and Installation Manual for information on
configuring the Sun PU2.1 SNA Server for use with your particular client.
14. Before you begin operations, make sure that you have licenses for each of
your client connections. For more information about adding licenses, refer
to Section 11.2, “Managing Licenses,” on page 11-6.
3.2 Starting the SunGMAN
When you install the SunGMAN software, start-up scripts that run when the
Unix system boots up are created and linked to the start-up area. To start the
SunGMAN manually, use the
sunsetup
command. By default,
sunsetup
is
located in the
/etc/Sun
directory.