Sun Microsystems SunLink SNA 9.1 PU2.1, Руководство по настройке

Страница: 197 / 298

Troubleshooting 12-19
12
Sunscope Options
The command line options that you can use when activating the Sunscope
utility. Separate command line options with a space. Valid command line
options are as follows:
Table 12-3 Sunscope Command Line Options
Options Description
-e Display hexadecimal numbers as EBCDIC characters.
-t Required for all LAN devices (IBM Token Ring, Ethernet,
FDDI).s
-c Required for channel devices on Integrated Gateway
systems.
-m dest_addr Display only frames sent to and from the destination
Medium Access Control (MAC) address specified by
dest_addr. All other frames are filtered out. The
destination MAC address is a 12-digit hexadecimal value
in the format
0x400010000012
.
-x xmit_size Set the maximum length for a display of a transmitted
packet to xmit_size bytes. If a transmitted packet exceeds
xmit_size bytes, only the first xmit_size bytes are
displayed.
-r rcv_size Set the maximum length for a display of a received
packet to rcv_size bytes. If a received packet exceeds
rcv_size bytes, only the first rcv_size bytes are displayed.
-p pattern Match the pattern specified by pattern against a packet.
The pattern is a hexadecimal value and can be any
length. If you use the
-o
and
-l
command line options,
the pattern is matched against the portion of the packet
that starts offset bits from the beginning of the packet and
extends for length bits. Make sure that pattern is greater
than or equal to length bits.