Sun Microsystems SunLink SNA 9.1 PU2.1, Руководство по настройке

Страница: 207 / 298

Troubleshooting 12-29
12
Start Time (traceStartTime)
The time to start the trace in the format HH.MM.SS. The default is Now.
Duration (traceDuration)
The length of time in seconds that you want the trace to run. (When the trace
file becomes full, the trace ends even if the specified time has not elapsed.)
Records Per File (traceNumTracePts)
The number of trace points to write to the trace file. The value can range from
1 to 10 000. The default is 1 000.
Action on File Full (traceFileFull)
The action to perform when the number of trace points specified by the
Records Per File parameter has been written. The value can be Stop Trace or
Continue.
If you select Continue, when the file specified by the Output File parameter
becomes full, the software creates a new file called filename.1 (where filename is
the file specified by the Output File parameter) and continues to write trace
points to filename.1. Note that only two trace files are maintained. When
filename.1 becomes full, new trace points are written to filename, overwriting
any existing data.
4. To accept the settings, click OK. To exit a dialog box without accepting the
settings, click Cancel. To return to the default settings, click Reset.
12.1.4.2 Starting a PU2.1 Server Trace
▼
To start a PU2.1 server trace:
1. Select Window
→
Active Traces List to display a list of configured PU2.1
server traces.
2. Click the PU2.1 server that you want to trace.
3. Select Control
→
Start Server Trace to start the trace.
12.1.4.3 Reading the PU2.1 Server Trace
A sample trace point is shown below.