Sun Microsystems SunLink SNA 9.1 PU2.1, Руководство по настройке

Страница: 124 / 298

8-4 SunLink SNA 9.1 PU2.1 Server Configuration Guide—August 1997
8
DEPLUFF
). If you are creating 255 dependent LUs and enter the string
DEPLU%03d
, the software creates a group of dependent LUs with the prefix
DEPLU
followed by 3-digit decimal numbers (
DEPLU001
,
DEPLU002
, . . . ,
DEPLU255
).
Keep the following in mind when specifying the name of a group of multiple
dependent LUs:
• Since the entire name (including the prefix and the generated number) is
limited to a total of 8 characters, if you plan to use 3-digit numbers in the
number field, make sure that you limit the prefix to 5 characters or fewer.
•
If you do not specify the size of the generated numbers, the generated
numbers are appended to the prefix without leading zeros.
• By default, the generated numbers that are appended to the base name are
sequential. If the numbers assigned by your host network administrator
are not sequential, you must modify the numbers of individual LUs after
they have been created. For more information on modifying dependent
LUs, refer to Section 8.2, “Modifying Dependent LUs,” on page 8-8.
LU Type The LU type. The value can be LUType 0, LUType 1, LUType 2,
LUType 3, or LUType 6.2). Select LUType 1 for 3770 RJE. Select LUType 2 if the
LU is used for 3270 terminal emulation. Select LUType 3 if the LU is used for
printing. Select LUType 6.2 for APPC peer-to-peer communications.
Note that if you are using either an LUType 1 or an LUType 3 for printing,
always select LUType 3, even if the actual printer stream is LUType 1. You can
still use LUType 1 when specifying the LU type to the host and when
configuring the VTAM LU.
Base LOCADDR
The address of the LU (for a single dependent LU) or the address of the first
LU (for a group of multiple LUs). The address can range from 1 to 254. The
default is 001 (if this is the first LU you are configuring) or the first sequentially
available address (if other LUs are already configured).
Check with your host network administrator for the correct address to use. The
address should match the
LOCADDR =
parameter of the LU definition in either
the VTAM or the NCP Gen on the host. If the address you specify has already
been assigned to an LU on the current PU, the screen displays an error
message requesting that you change the address.
Note that the addresses generated for additional LUs in a group of multiple
LUs are sequential, starting with the Base LOCADDR. If the addresses
assigned by your host administrator are not sequential, you must modify the