Stratasys P750K, Руководство пользователя

Страница: 179 / 196

DOC08010 Rev. A (DRAFT 1)
6–63
Stratasys P750K User Guide
7. Pull ȱ the ȱ lamp ȱ reflector ȱ out ȱ of ȱ the ȱ print ȱ block.
Figure 6-103: Removing the UV lamp reflector
8. Inspect ȱ the ȱ new ȱ lamp ȱ reflector, ȱ and ȱ make ȱ sure ȱ that ȱ a ȱ black ȱ strip ȱ is ȱ
attached ȱ to ȱ the ȱ inside ȱ of ȱ it. ȱ If ȱ not, ȱ install ȱ one—on ȱ the ȱ side ȱ of ȱ the ȱ
reflector ȱ opposite ȱ (not ȱ next ȱ to) ȱ the ȱ print ȱ block.
Note: Extra black strips are included in the printer Start-up Kit. If
necessary, you can remove the black strip from the old reflector and install
it in the new reflector (as long as the black paint has not faded).
9. Discard ȱ the ȱ old ȱ reflector ȱ and ȱ lamp.
Dispose of the used UV lamp in accordance with environmental and safety
requirements.
WARNING: Broken lamp hazard.
UV lamps contain mercury. Deal with broken lamps with caution.
¾
Ventilate the room thoroughly.
¾
Use protective gloves when collecting mercury and lamp components.
¾
Remove spilled mercury with a method that prevents the generation of
mercury vapor, such as a syringe, packing tape or paper.
¾
Place the broken lamp, mercury and contaminated materials in an air-
tight, non-metallic container.