ID 442426.04
271
WE KEEP THINGS MOVING
Communication
14
Manual SD6
14.3.2.2
Setting up a direct connection automatically
The following requirements must be met to set up a direct connection
automatically:
•
The computer and gateway device or the IGB network must be connected
via a network.
•
The drive controller must be turned on.
•
You have created a project in DriveControlSuite.
Information
A change to the parameter will not take effect until
- the value is saved with action
A00[0]
and the drive controller is
turned off and back on again
- or the physical connection is terminated.
0: manual
The drive controller is using exclusively
assignments from
A164[x]
and
A165[x]
.
The active values are displayed in parameter
A157[x]
and
A158[x]
.
1: standard
The drive controller uses the assignments
from the DHCP server or DriveControlSuite.
If no assignment is received by the DHCP
server or DriveControlSuite within 3 minutes
after connection to the network, assigned
values from
A164[x]
and
A165[x]
are used.
The active values are displayed in parameters
A157[x]
,
A158[x]
,
A160[x]
and
A161[x]
.
2: only DHCP
The drive controller uses exclusively
assignments from the DHCP server.
The active values are displayed in parameters
A157[x]
,
A158[x]
,
A160[x]
and
A161[x]
.
Setting up a direct connection automatically
1. In your project in DriveControlSuite, select the module with which you
would like to set up a direct connection.
2. In the bottom part of the project window click the
Make connection
button.
The
Make connection
dialog for the module opens:
The dialog shows all the gateway devices that are connected with the
network.
3. Select the gateway device with which you would like to set up a direct
connection. If a green or yellow dot appears in the
IP address
column for
this device, a connection can be set up automatically. If a red dot appears,
it is not possible to set up the connection.
