ID 442426.04
211
WE KEEP THINGS MOVING
Motor
10
Manual SD6
10.2.2
Parameterizing motor data
You must specify motor data for correct control. There are several ways to do
this:
•
You can select a standard motor in DriveControlSuite. In this case the data
will automatically be entered in the correct parameters. A description of the
selection can be found in section 10.2.2.1.
•
If you are using a synchronous servo motor with EnDat encoder that has
been configured for operation on a STOBER drive controller, you can
activate the electronic rating plate. In this case the drive controller will read
the motor data from the rating plate every time the device starts. Activation
of the electronic rating plate is described in section 10.2.2.2.
•
If you would like to operate a motor from another manufacturer on the
STOBER drive controller, enter the motor data in the parameters manually.
To see which parameters must be edited, see section 10.2.2.3.
10.2.2.1
Selecting a standard motor
Requirements:
•
You have created a project in DriveControlSuite.
Selecting a standard motor
1. In your project, click on the axis for which you would like to select a
standard motor.
2. Click on the
Projecting
button in the bottom part of the window
The projecting dialog appears.
3. Select the
Motor
tab.
4. Use the three picklists in the top part of the dialog to adjust the motor
group to which the motor is assigned, for example
STOBER standard
motor
,
synchronous motor (servo)
and
EZ motor
.
The corresponding motors are shown in the list near the bottom.
5. Check the check box in the first column to select the motor that will be
operated on this axis.
6. Confirm the projecting dialog with the
OK
button
You have selected a standard motor. The motor data is entered in the
project.
