2-16
BRC-300/300P
BRU-300/300P
B2
x
3
PSW2
x
6
CN052
Connector
CN051
CD-389 board
VC-343 board
Flexible flat cable
Camera assembly
2-2-7. IF-944 Board and VC-343 Board
Removing
1.
Remove the side rear assembly and side front assem-
bly. (Refer to steps 1 to 3 in Section 1-3-1.)
2.
Remove the camera cabinet upper assembly.
(Refer to steps 2 to 5 in Section 1-3-2.)
3.
Remove the camera cabinet lower.
(Refer to steps 3 to 5 in Section 1-3-3.)
4.
Remove the SE plate.
(Refer to steps 2 to 4 in Section 2-2-9.)
5.
Remove the camera assembly.
(Refer to steps 5 to 13 in Section 2-1-1.)
6.
Remove the shield chassis.
(Refer to step 6 in Section 2-2-6.)
7.
Disconnect the flexible flat cables from the connectors
(CN051, CN052) on the VC-343 board.
8.
Disconnect the connector on the CD-389 board
(flexible card board).
9.
Remove the two screws.
7.
Disconnect the flexible flat cables from the connectors
(CN201, CN301, CN302) on the IF-110 board.
8.
Remove the two screws, and remove the IF-110 board
from the camera assembly.
Installation
9.
Reinstall the IF-110 board to the camera assembly in
the reverse order from steps 7 and 8.
10. Perform the BRC-300/300P camera block electrical
alignment. (Refer to Section 3-2.)
11. Reattach the shield chassis to the camera assembly,
and then fix it with the four screws.
n
Replace the tapes A with new ones as necessary.
12. Reassemble the unit in the reverse order from steps 1
to 5.
IF-110 board
CN201
CN301
CN302
B2
x
3
Flexible flat
cable
Flexible flat
cables
Camera assembly
