2-11
BRC-300/300P
BRU-300/300P
Combined flexible flat cable
Tapes A
M2
x
3
Ferrite bead
Tape A
Holder (B)
2-1-9. Combined Flexible Flat Cable
n
The combined flexible flat cable mentioned here consists
of two cables that are stuck to each other.
Therefore, replace them together.
Removing
1.
Remove the base plate. (Refer to Section 1-3-4.)
2.
Remove the SY-314 board.
(Refer to steps 2 to 4 in Section 2-2-11.)
3.
Remove the blank panel.
(Refer to step 1 in Section 1-3-5.)
4.
Remove the EXP chassis assembly and CC-91 board.
(Refer to steps 4 to 6 in Section 2-2-1.)
5.
Remove the pan motor.
(Refer to step 3 in Section 2-1-7.)
6.
Remove the side rear assembly and side front assem-
bly. (Refer to steps 1 to 3 in Section 1-3-1.)
7.
Remove the camera cabinet upper assembly.
(Refer to steps 2 to 5 in Section 1-3-2.)
8.
Remove the camera cabinet lower.
(Refer to steps 3 to 5 in Section 1-3-3.)
9.
Remove the SE plate.
(Refer to steps 2 to 4 in Section 2-2-9.)
10. Remove the camera assembly.
(Refer to steps 5 to 13 in Section 2-1-1.)
11. Remove the DR-526 board.
(Refer to steps 2 to 4 in Section 2-2-5.)
12. Remove the ferrite bead from the combined flexible
flat cables and remove the tape A.
13. Remove the screw, and remove the holder (B) from the
base cabinet assembly.
14. Remove the four tapes A.