Skyranger Nynja, Руководство по сборке

Страница: 262 / 278

262
Nynja Build manual 1.4d
A touch of oil / grease on the hinges works wonders
h) Ensure that the tubes which the aileron cables touch are protected by
oversized pieces of prop tape or similar.
There are some small pieces of tubing on the aileron cables. These are
fairleads that should be positioned on the top of the TU38 tubes to stop
the cables rubbing as they pass over. Hold these in position with two
small cable ties. Take care not to flatten the tube with excess cable tie
tension.
Figure 368 cable guide
i) Check the neutral position and operation of the elevator.
The elevator should be horizontal with the lower half of the stick at 90

to the central cabin tubes, not vertical.
Elevator movement should be 25

each way. If necessary file the stop
positions on the stick pivot piece to increase movement.
j) Ensure the rudder-stop cables have been properly crimped and fitted.
k) Check the neutral position and operation of the rudder and nose-wheel.
With the rudder straight, the nose-wheel should be straight. Rudder
movement should be 25

each way. Nose-wheel movement should be
symmetrical each way.
l) Wire-lock all turnbuckles.
m) Check the correct operation of the brakes.