Skyranger Nynja, Руководство по сборке

Страница: 93 / 278

93
Nynja Build Manual 1.4d
Figure 109 cable routing past flap handle.
The cables pass close over the top of the tubes. Check the clearance
with some tension in the controls, rather than just slack.
If the cables rub on the flap actuating rod, check that the lever is fitted
as per the instructions, particularly on its position to starboard and the
spacing of the detent lever. If this does not cure the problem, space the
starboard spacer tube at the rear end of the flap handle out with
washers and shorten the port spacer tube.
d) Check that the elevator deflects upward when you pull the stick back
toward the rear of the aircraft.
e) Tension the turnbuckles by hand, keeping the elevator central when the
stick is at 90

to the cabin central tubes tu19 (not vertically upwards).
f) Check the elevator moves smoothly, without binding.
It is not necessary to have a lot of tension in the cables.
g) Check that the rubber stop-rings on the joy stick act against the edges of
the stick pivot, forming the control stops.
When moving the stick forward or backward you should have around
25

of deflection in the elevator each way. If necessary, adjust this by
filing the top and bottom edges of the stick pivot piece where the stop-
rings bear. These are somewhat flexible, so set the deflection with
some pressure on the stick.