Skyranger Nynja, Руководство по сборке

Страница: 132 / 278

132
Nynja Build Manual 1.4d
s) Lay the wing flat on its lower surface. Give the elading edge rope a pull to
ensure frame is snug in the tip of the sail.
t) Replace the turnbuckle on the drag cable and tighten by hand until the other
cable comes taught, which may require some effort.
The cable with the turnbuckle goes over the other cable.
If the cable without the turnbuckle will not tighten up, check that the
covering is properly seated along the leading edge.
u) Install the two large diameter battens ( SKR184 curved, SKR185 straight) at
the wing root end of the wing covering,
They are inserted through the holes at the trailing edge of their pockets
(look closely, they are there), not through the holes further forwards.
Push the battens in as far as they will go and slip them into the wing
root side of the pocket so that they are held securely in place.
Figure 158 large diameter wing root battens.
v) Install the two wing tensioning tubes ( SKR32 and SKR33 ) against the
outboard side of the large diameter battens.
Cut the ends of the tensioning tubes at an angle, on the sides opposite
the holes, and finish them nicely. This prevents them cutting into the
fabric.
They will fit into the holes cut in the fabric for this purpose. The longer
end of the tensioning tubes goes uppermost. The holes cut into these
tubes must clip over the battens, and the threaded rod must enter the
holes in the compression tube, figure 159