199
Nynja Build manual 1.4d
h) Push the windscreen into position behind the cowling lip, wrap around the
sides and clamp into position on the cabin uprights.
Take care
– the lexan is quite springy and if its edge is bashed against
the glassfibre cowling edge it can cause chunks to be taken out. Two
people makes easier work at this stage.
The windscreen pattern is intended to be oversize at the front. Insert
the screen and position carefully, mark a cut line aiming for a neat
overlap of 25mm.
– maybe more along the side if the side pockets are
being fitrted
– look forwards to that section now to see why.
Take care that the tubes
tu34
supporting the windscreen do not get
knocked out of position, check them regularly, and check that the shape
of the cowling remains as it should be otherwise you may build a
strange shape into the windscreen and the cowling!
The drawn centreline is a useful reference and should end up in the
dead centre of the cowling.
Figure 267 windscreen over lap inside cowling (note we painted the overlap to match interior
fabric trimming.
i) Rivet the Lexan every 15cm or so to the large curved tubes on the top sides of
the fuselage.
Use the pre-drilled holes, start at the rear and work towards the front of
the Lexan.
Clecos / skinpins can be used first rather than going straight for rivets.
Peel back the securing film so it is not trapped between the TU34 and
the lexan and under the rivet heads
– it won’t be easy to get out
afterwards..
Use the black 4mm aluminium rivets.
j) Get two helpers, one on each side of the fuselage pushing the Lexan tightly
into the inside of the curved part of the cowling.
Содержание Nynja
