Skyranger Nynja, Руководство по сборке

Страница: 197 / 278

197
Nynja Build manual 1.4d
c) Cut the main windscreen Lexan sheet to the drawn pattern.
Cut a little oversize at the front, and sides to start with
– these will be trimmed
to fit later. (cut oversize especially at the front
– by at least 30mm)
Draw an accurate centreline on the protective covering film
– this will help later
to ensure everything is straight and centred.
A good tool for cutting lexan is straight tin snips as shown in the picture below.
Edges cut with tin snips should be dressed smooth with sandpaper over a
sanding block.
For more intricate curves a Dremel cutting toll can be used followed by using
the sanding drum attachment.
To trim excess from edges, a Surform tool has been found to be useful.
Figure 264 cutting the Lexan to the pattern.
d) Drill the two rear holes marked on the rear part of the Lexan.
e) Lay the Lexan over the cockpit, locating the holes in the Lexan over the two
bolts sticking up at the rear of the cockpit.
Check that you have not left the leading-edge securing pins in place, as
if you do, and they are incorrectly inserted from the front instead of their
proper insertion from the rear, you will not be able to get them out again
when you have fitted the windscreen!