Skyranger Nynja, Руководство по сборке

Страница: 124 / 278

124
Nynja Build Manual 1.4d
g) Attach the starboard aileron cable end to the stainless steel plates on the
starboard side of the aileron horn using a shackle pin and a nappy pin or split
ring.
h) Attach the stainless steel plates on the port aileron cable to the port side of the
aileron horn using a shackle pin and nappy pin or split ring.
i) Attach the turnbuckles to the upper control horns.
Figure 150 aileron cable fuselage pulleys.
j) Select the other aileron cables ca6 which are connected in the middle by a
single turnbuckle.
k) Pass the ends of the cables ca6 over all the tubes in the wing and the
fuselage (except the windscreen supports) and around the lower pulleys inside
the wing.
Loosen the turnbuckle and feed the other ends from the fuselage
outwards towards the ailerons.
l) Attach the ends to the lower control horns on the ailerons.
m) Tighten the bolts securing the aileron pulleys in the wings.
Ensure the pulleys can still move to take up the correct angle to the
cables.
n) Check the gap between the pulley and the plates to make sure that it is not
more than 1mm or so.
If it is, there is a chance that the cable could jump the pulley and slip
between the plate and the pulley. If there is an excessive gap, check
the plate for bends and check for the proper washers between the
pulley and the plate.
o) Tension the cables by hand to check that all the cable lengths are accurate.
p) Check the angle of the lower pulley bracket inside the wing.
This is the bracket for the cable ca6 that connects to the lower control
horn on the aileron. You will need to bend the bracket with a twisting