2-9
2
Ba
sic O
pe
ra
tio
n
7
Raise the pressure roller up / down lever.
Note
-
There are three selectable positions (up,
middle and down) on the pressure roller up /
down lever.
-
To raise the (release) the pressure roller here,
raise the pressure roller up / down lever to the
top position. (
P.2-26 ([How to switch the
pressure])
8
Feed the media between the pressure roller
and grid roller and advance the media until
the leading edge of media comes out of the
Front cover.
Advance the media until the leading edge of
media comes out at a distance of 200 mm
When the leading edge of media comes
out of the Front cover, a confirmation beep
sounds.
Note
-
Depending on the environment, it may be hard to advance the media due to it
sticking to the paper guide. In this case, advance the media while raising the
media from the paper guide by holding both edges of media by hand.
- If the leading edge of media is curled up or curled down, the media may be caught
in the printer and may not be set. If the media is curled too much, do not use it.
- Be careful that the leading edge of media does not to touch the Front cover.
If the roll media has a rolling tendency, stretch the media to eliminate the rolling
before loading.
- Ensure that the media edge guard does not enter under the media.
q
Media replacement
IP-5610取説_E.indb 9
09.4.3 3:13:48 PM
