Oki ES9160, Руководство по обслуживанию

Страница: 427 / 1087

6
© 2012 OKI DATA CORPORATION All rights reserved ES9160 MFP / ES9170 MFP
SETTING / ADJUSTMENT
6 - 119
[A] Registration of the number of punch holes
(1) Turn OFF the power of the equipment.
(2) Take off the rear cover of the finisher.
(3) Set the bits 1, 2 and 4 of the DIP switch [2] on the hole punch control PC board (HP) [1] to ON.
Then turn ON the power of the equipment while pressing the pushbutton switch [3] on the hole
punch control PC board (HP) [1] and the digital keys [0] and [8] on the control panel of the
equipment.
Fig.6-136
(4) Select the number of punch holes by setting the bits from 1 to 4 of the DIP switch [2].
See the table below for registering the number of punch holes.
(5) The number of punch holes is registered in the hole punch control PC board (HP) [1] by pressing
the pushbutton switch [3].
LEDs [4] on the hole punch control PC board (HP) [1] start blinking as the registration is started.
When the registration is completed, the LEDs [4] are lit.
(6) Turn OFF all bits of the DIP switch [2].
(7) Install the rear cover of the finisher.
Number of punch holes
DIP switch
1 2 3 4
2 holes (E) OFF OFF OFF OFF
2/3 holes (N) OFF OFF OFF ON
4 holes (F) OFF OFF ON OFF
4 holes (S) OFF OFF ON ON
[1]
[2]
[3]
1 2 3 4
ON
CPU
LED
[4]